Can you make a rocket out of carbon fiber PLA?

Sure you can. As long as you’re talking about a carbon fiber Rocket Racoon. All joking aside, I made this prior to the Long Beach Comic Con as a demonstration piece for the Ultimaker 2.

The first one came out very well for being printed in one pass – no parts, no orientation tricks. I think people always want to know – especially 3d modellers – how well a 3d printer will work with their models. The answer is always it depends, but so far the Ultimaker 2 has really dared me to do things that are more difficult.

The results of this test aren’t perfect, but they are impressive considering the level of “difficulty” of this model.

Test-render-00003_001

The basic figure was sculpted in Sculptris which thankfully is still free. The figure was posed and the gun was added with Lightwave 3d. I also made the model watertight – if you don’t know what that means, it’s made into one continuous polygon mesh – also in Lightwave. But the software is less relevant than the material – Carbon Fiber reinforced PLA.

Although this came out better than I expected, I should have increased the wall thickness of the print.

As a result the legs broke when I cleaned the model. But, I am used to cleaning and polishing plastic models. What red blooded teen-aged boy didn’t spend hours making plastic models seamless?

Some Tamiya modeling putty and 2 grains of sandpaper (60-120 grain) will make this raccoon whole again, but since the test was meant to see how the untouched surface would hold up – well I think it’s still successful as the finish is actually very good by default.

Chances are you have everything you need around the house when you first get a 3d printer – especially if you are already a hobbyist of some skill level. The only thing I really didn’t have lying around which made this much easier was the Tamiya putty – which is terribly expensive by volume. I think I would DIY an alternative since basically it is a quick drying semi-polymer based, molding putty. Time to break out the chemistry set.

Even printed at only 100 microns (mostly for speed), the model printed well for something with an enormous amount of overhang issues. People constantly tell those who do 3d printing to try and avoid overhangs by orienting parts in certain ways. And that’s still true but I like to torture test materials and equipment with tough situations and this guy has every DON’T DO THAT issue related to 3d printing there is.

For more information on the ultimaker 2 and Carbon fiber reinforced filament, visit https://www.ultimaker.com/ and http://www.proto-pasta.com/

And sign up for important private invites and announcements. I want to offer something to the courageous soon.

[mc4wp_form]

 

Follow here Facebooktwitterlinkedinrssinstagramby feather